Cabling College Essays Samples For Students

Technology

Discussion on Inclusion/Exclusion of Fiber Optics and UTP Cabling Design for Gates Widget Company

Fiber Optics an UTP Cabling in Design

Mr. B. Gates the owner of Gates Widget Company has ordered to design a cable network that will be used for the three buildings in the companys premises namely, Day care, factory and the administrative building. The focus of discussion in terms of inclusion and exclusion of cabling technology is for the administrative building. There are two types of cables that will be used in the design. First is the UTP or unshielded twisted pair which has a maximum VDV ( ...

Technology

Use of UTP and Optic cable in network design
Looking at the various aspects of both the UTP and optic cable, optic cable has more advantages than the twisted pair cables. However, due to economic constraints and other aspects of the network being designed, the network designer and administrator may opt to use the UTP instead of the optic cable in some parts of the network architecture instead of a purely optic cable network.
Looking into Gates network design and the basic requirements of the three units to use the network, one can use either of the two ...

Advantages of the ANSI/TIA/EIA cabling standards

ANSI/TIA/EIA cabling standards are telecommunication standards defined by the telecommunications industry association. It is a standard that was developed in order to address commercial building for cabling and other telecommunication products. TIA/EIA defines a structured standard that allows a cabling system environment that will see to it that in future the same will be acceptable to the available technology. These standards offer many benefits that all managers in the field of telecommunication should be aware of. The standards specified in offer many advantages in the area of telecommunication (Khalil et al., 2009).
It s to be considered that the first advantage ...

Company network architecture

Part I
In designing a network, several factors are considered and are dictated by the use of the network. Looking at the case in hand, the network is supposed to address the five departments each separately, communication within the departments and within the local geographical locations (California and New Jersey) and intercity communication between the two business units.
Looking at the five departments, each department should have its own network so as to operate effectively. This means that the department will have its own network architecture depending on the number of employees it has. The main objective of ...

Setting up of a home internet network and an office

How should this person set-up a home wired network. (Let's leave wireless out of this for now.)
Include a simple diagram showing the network.
When setting up an internet network in an office, one must look at the speeds achievable and the purity of the data transmission. Obviously both DSL and cable internet have their virtues but DSL is probably better for this type of small office setup as it runs at a lower cost than cable which is also harder to install.
One may use cable for a small network but as indicated, the costs are rather high when ...

Capstone Proposal Introduction

This document is an IT project proposal created for Chugach Alaska Corporation’s Wake Atoll contract and for XXX University to satisfy the requirements for the TWA1 Technical Writing course, one of the final requirements in the Bachelor of Science in IT.

Wake Island Atoll is a small cluster of islands located between Japan and Guam just across the international dateline. United States acquired possession after its victory over Spain in the Spanish-American war . Later in WWII, the Japanese invaded and took possession until the Japanese surrendered. Today, the island is a somewhat sleepy place. Other than occasional stopover from flights ...

Designing a Home Network

A home network is a local area network in a residential setting that is used for communication between digital devices such as personal computers, printers and mobile computing devices (Wikipedia, 2011). Wireless technology is an ideal choice for a network in the home. Wireless technology follows the Institute of Electrical and Electronic Engineers (IEEE) 802.11 specifications.
The 802.11g wireless technology is ideal for this home network. It has a maximum data transfer rate of 54 Mbps and a total transmission distance of hundreds of feet. It runs on the 2.4GHz unlicensed band and supports 20 users per cell (Lammle, 2007). The network consists ...

Introduction

Networks play a very important role in businesses and governments. Networking is being developed so that new techniques are making communication effective today. There are various designs that are available that companies can adopt. The design that is chosen will depend on the business requirements and the size of the company. This paper will look at the network designs that can be implemented in organizations. It will also look at the merits and demerits of each network.
This topology is characterized as a multi point medium. That all station is being attached through this hardware (a network adaptors) as a linear transmission ...