Inlet College Essays Samples For Students

Basic Modules of Gas Turbine High Bypass Engine

Air Inlet Section: As shown in figure 5, the air inlet section is the most forward section of the engine. This section forms the air inlet for the engine and houses the inlet guide vanes. The purpose of the vanes is to direct the incoming air at the proper angle to the first fan stage. The vane at the bottom of the air inlet is thicker than the others in order to accommodate engine tubing. As indicated in figure 6, the no. 1 bearing support assembly is mounted in the center of the compressor inlet case. Behind the front ...

1.0 Lab 1: Heating Value Measurements: Solid and Liquid Fuels with a Bomb Calorimeter
1.1 Introduction
Measurements of heating values can be derived for both solid and liquid combustible fuels using an Oxygen Bomb Calorimeter. The calorimeter measures heat. Heat is not the same thing as temperature. The heat of combustion is called the calorific value. The calorific value is “:the number of heat units liberated by a unit mass of a sample when burned with oxygen in an enclosure of constant volume” (Introduction 2007). The experiment uses the 6100 Bomb Calorimeter. The definition of calorific value in a bomb calorimeter ...

Lab Report

Lab Report

Introduction

Air stripping lacks an official academic definition, but a widely accepted definition within the field regards it as the transfer of contaminants from aqueous solutions to air [1]. This process is commonly performed to decontaminate waste water and groundwater for public health purposes, given its ample use in the removal of volatile organic compounds (VOCs) from water into air. Air strippers, the devices that carry out this process, are composed of a cylindrical tank which can contain different materials such as steel, ceramic or plastic. Contaminated water is pumped into the apparatus through its upper inlet, proceeds ...

Piston: Pistons of 4-stroke engine moves between Bottom Dead Centre (BDC) and Top Dead Centre (TDC) to complete a single thermodynamic cycle. Latest 4-stroke automobiles are designed to run on unleaded petrol. A 4-stroke engine is called an internal combustion engine, where the piston completes 4-separate strokes they are intake, compression, power and exhaust. The intake stroke of the piston moves down (or BDC) and the engine takes a cylinder full of air and petrol. Then the piston moves back (TDC) and thus compress the petrol and air mixture. When a piston reaches at the top the spark plug of the engine ...

Introduction

Energy is a key driver of any nation’s economy. The extent to which it contributes to the performance of all activities surrounding the human life is beyond measure. This is because energy contributes almost fully to the economic development of the economy. In its physical form, energy is classified either as renewable or non-renewable. Renewable energy forms the green energy that can be reused again and is less toxic to the environment. On the other hand, non-renewable energy is exploited once it’s used and mostly pollutes the environment. All this energy forms can be either used directly ...

Introduction

When the word “fluid” is mentioned in everyday language, many think that it simply refers to liquids. However, in the world of physics, the term fluid has an entirely different meaning. It denotes any liquid or gas that has the ability to adjust or conform to the shape of the container in which is it being held. Fluid mechanics refers to the study of fluids in motion and at rest. Fluid mechanics is usually divided into two subsections. The first subsection is referred to as fluid statics. This is primarily concerned with studying those fluids are stationary or static. ...

Abstract

Heat transfer through a cylindrical pin fin s studied. For the purposes of this study, thermal conductivity, heat transfer coefficient and the source terms and the sink terms are assumed to depend on the temperature. In the model being used for the study, the source and sink terms are given as arbitrary functions. We therefore employ techniques on symmetry to find the forms of the source and the sink terms which the extra lie point symmetries are admitted. The method of separating variables is used in the study to get the exact solutions when the equation for the equation is ...